Thank you for choosing Enduce E1
Assembly instructions
Instructions for installation in joists and internal mounting.
Instructions for use
Instructions for cleaning and maintenance.
Brochure Enduce E1
Descriptive information about the purpose, value and company behind the product.
Dimensional sketch
External dimensions of the product.
Product data sheet
Brief information on the function and design of the product.
Link to more documents
Click here to access more documents.
FAQ
The installation of the Enduce energy recovery floor drain leads to a significant reduction of energy consumption during the operational phase (EPD module B1).
Calcareous water does not have a problematic impact on the floor drain either on the gray water side (used shower water) or the tap water side.
A hot water-based cleaning system heats, melts and flushes greasy deposits out of the heat recovery system's heat exchanger.
Series production and assembly take place mainly in Sweden. The product consists largely of recycled material. The brass is lead-free.
Enduce E1 meets the requirements of the Swedish National Board of Housing, Building and Planning. To date, the technology has been used over 15,000 times.
There are no regulations that prevent energy efficient technologies at the application level in showers.
How you design the shower area and where you position the shower room ventilation are important factors that influence how energy efficient and comfortable the shower experience will be.
According to independent studies, recovering hot water energy at the application level directly in the shower area is the most efficient way to recover hot water energy that would otherwise be lost.
More than 96% of resource consumption is used to heat shower water, while water use accounts for only about 4%.
The solution's operating principle is that the energy in the continuous flow of shower water is heat exchanged against the continuously incoming cold water.
The floor drain is designed to be fully repairable. This means that all internal and moving components can be replaced if something breaks.
The connection of the waterproofing to Enduce E1 is done via traditional clamping frame connections for either waterproofing foil for tiled floors, or for plastic carpet.
Please contact us
Alexander Teir
Technical seller
aleksander.teir@enduce.se
079-103 56 56
Thomas Holmberg
CEO
thomas.holmberg@enduce.se
070-279 72 67
Henrik Hagman
Technology and product manager
henrik.hagman@enduce.se
070-947 57 43
Gustav Svenson
Designer and developer
gustav.svenson@enduce.se
070-234 57 29
